| 1 | <?xml version='1.0' encoding='UTF-8'?>
|
|---|
| 2 | <!DOCTYPE topic PUBLIC "-//OASIS//DTD DITA Topic//EN" "topic.dtd">
|
|---|
| 3 | <topic xml:lang="en-us" id="nat-adv-tftp">
|
|---|
| 4 | <title>Configuring the Boot Server (Next Server) of a NAT Network Interface</title>
|
|---|
| 5 |
|
|---|
| 6 | <body>
|
|---|
| 7 | <p>
|
|---|
| 8 | For network booting in NAT mode, by default <ph conkeyref="vbox-conkeyref-phrases/product-name"/> uses
|
|---|
| 9 | a built-in TFTP server at the IP address 10.0.2.4. This default
|
|---|
| 10 | behavior should work fine for typical remote-booting scenarios.
|
|---|
| 11 | However, it is possible to change the boot server IP and the
|
|---|
| 12 | location of the boot image with the following commands:
|
|---|
| 13 | </p>
|
|---|
| 14 | <pre xml:space="preserve">$ VBoxManage modifyvm <varname>VM-name</varname> \
|
|---|
| 15 | --nattftpserver1 10.0.2.2
|
|---|
| 16 | $ VBoxManage modifyvm <varname>VM-name</varname> \
|
|---|
| 17 | --nattftpfile1 /srv/tftp/boot/MyPXEBoot.pxe</pre>
|
|---|
| 18 | </body>
|
|---|
| 19 |
|
|---|
| 20 | </topic>
|
|---|
